Analysis of common failure causes of linear vibrating fluidized bed dryer

There may be some common small faults during the use of the linear Vibrating Fluidized Bed Dryer. Generally, how do we find the reasons for these small faults? We can find out through the fault analysis corresponding to the common faults. Causes to find practical solutions.

Fault 1: The temperature display is different from the set temperature. There are several reasons for this, mainly including insufficient steam pressure, failure of steam sensor, failure of electric heating heating, failure of temperature sensor, and too large damper of exhaust air duct.

Fault 2: The fuselage moves laterally. There may be two reasons for this: the eccentric block of the vibration motor is not synchronized, and the air volume at the feed end is too large.

Fault 3: The discharge speed is too fast. The cause may be that the feed end component is too large, or the included angle of the eccentric block of the vibration motor is too small.

Fault 4: The discharge speed is too slow. The cause may be that the weight of the discharge end is too large, and the included angle of the eccentric block of the vibration motor is too large.

Fault 5: There are large particles at the discharge port of the cyclone dust collector. The cause may be that the air intake is too large and the air volume of the induced draft fan is too large.

Among these failures of the linear vibrating Fluidized Bed Dryer, the corresponding causes can be checked to see if they are serious, and the problems should be found and solved in time, so as not to cause major failures.